清潔電腦時吸塵器的自製吸頭(Cleaning your PC with a vacuum cleaner and DIY Suction head)

在清潔電腦的時候，我喜歡在室內工作

When cleaning the computer, I like to work indoors.

但使用空氣罐跟空壓機，灰塵會到處亂飛，只能到室外作業

But the use of air tank with air compressor, dust flying around, only to outdoor work.

室外作業的光線常常不足，每次吹完也不曉得是不是真的乾淨了

Outdoor work light is often not enough to see the cleaning effect.

灰塵飛一飛可能又飛回到主機板上

Possible dust flew back into the system.

最後還是決定使用吸塵器（個人使用DYSON）

Finally decided to use a vacuum cleaner (for personal use DYSON).

可惜，吸塵器幾乎不太針對電腦設計吸塵配件

Unfortunately, there are few in Taiwan, designed for computers suction head accessories.

因此小弟自己diy了一個

Therefore, an own diy.

市面上很難找到完全透明的蛇管，完全透明的塑膠管又不好彎曲，也就不好作業

In Taiwan, the market is difficult to find a completely transparent snake tube, completely transparent hard plastic tube bending, it is not good to work.

於是從「油抽」取下的米色蛇管
So from the "oil pump" beige snake tube removed.

五金行取得，三芝鄉下好像才賣85元的樣子，太原路賣到200的樣子（破百就是了）

Hardware store to obtain, near my home and sold $ 2.5 seems like, Taiyuan Road sold for $ 7 look.

中型油抽（網拍網址）

Medium oil pump (racquet website).

http://ppt.cc/JmTE

用美工刀切開，重複多切割幾次就分開了，施工請小心
With art knife to open, repeat several times more cutting parted, careful construction.

因為我的吸塵器設計的卡準，所以貼上了幾圈膠布增加厚度
Because my vacuum cleaner designed slot, so a few laps tape affixed to increase the thickness.

加上一種硬式筆桿附毛刷橡皮擦（文具店取得35元好貴）
Plus one kind of hard pen eraser brush attachment (stationers sell $ 1.5) 

蛇管
Snake tube.

全貌
Complete picture.

刷頭算是有點硬，使用力道請自行注意，刷風扇、機殼角落、鍵盤比較好用

Brush be a little hard to use your power of self-regulation.

電路板的部份藍藍路建議可先用吹風機吹過，再用軟毛刷（油漆刷？）比較好刷

It was suggested that part of the board first with a hair dryer blowing a few seconds, and then a soft brush (or paint brush) is easier to brush.

使用起來可以說相當順手，可單手進行清潔作業（左手輔助），分享給各位
Using them can be quite handy, one-hand operation for cleaning (left hand to assist).